The Sporter PC Circuit Board replaces the circuit board found in the control box.

The Motor Cable for Control Box goes from the Control Box to the Junction Box and contains five individual wires.

This Release Cable includes the cable and three pin connector, it does not include the Female Bryant Plug or the Cable Clamp.

The Reed Switch is compatible with all Lincoln Infinity Series Automatic traps. The Reed Switch is critical to setting the stop position of the throwing arm.

For the escapement roller aids this O-ring should be replaced if it appears worn or if improper feeding is leading to broken targets.

The Rabbit Lower Brush Holder Assembly aids in the feeding of targets.

The Standard Brush helps guide the target into place before being thrown. Brushes can wear over time and need replacing.

The Female Bryant Plug is compatible with all Lincoln Infinity Series Automatic traps. This plug acts as a connection point for the release. 

The throwing arm is an aluminum rail with a polyurethane strip that makes contact with the target. This part must be replaced when the polyurethane becomes too worn.

The Chandelle arm is an aluminum rail with a polyurethane strip that makes contact with the target. This part must be replaced when the polyurethane becomes too worn.

Two of these are used on the cocking motor of every machine to seal the motor brush holders.

The GR10N Nut can be found on all Lincoln Infinity Series automatic traps.

The Control Box drives all of the functions of a Lincoln Infinity Series Automatic machine. This product includes a complete Control Box.

The Control Box Rocker Switch is an on/off/release switch that allows the user to perform those functions.

This boot covers the reset button on the 30 AMP Overload Circuit Breaker.

The Battery Power Cable for Control Box includes clips for easy use with a battery.

The Release Cable with Strain Relief includes the Female Bryant Plug and Cable Clamp.

The Motor Brush Set (2) is compatible with all Lincoln Infinity Series Automatic traps.

The Reed Switch Bracket Assembly is used to set the stop position of the throwing arm. Includes switch, bracket & hardware needed. 

This spring helps target feeding by allowing one target to drop from the magazine while holding the rest of the stack.

The Rabbit/Chandelle Brush is used to secure each target before it is thrown. This brush should be replaced if it is no longer securing the target properly.

The Male Bryant Plug is compatible with all Lincoln Infinity Series Automatic traps. This plug interfaces with the release cable that comes out of the control box.

Two of these are used on the cocking motor of every machine for added weather protection.

The Standard Rabbit arm is an aluminum rail with a polyurethane strip that makes contact with the target. Replace this when the polyurethane becomes too worn.

This bolt is compatible with all Lincoln Infinity Series Automatic traps.

he Relay is compatible with all Lincoln Infinity Series Automatic traps. The Relay is responsible for directing power to the motor when needed.

The TF203 lock washer is found on all Lincoln Infinity Series Automatic traps.

The Control Box Gasket seals the electronics within the Control Box from the elements. A new gasket ensures the interior of the control box remains protected.

This circuit breaker helps protect the electronics in the Control Box from damage.